How To Put Together A Succulent Garden

1
Begin at the start of the growing season. You may attempt to propagate succulents at any time of year. However, you may have the highest chance of success if you start near the end of the plant's dormant period, or at the start of the growing season.^[1] In most cases, this means early spring, but a few succulent species begin growing in autumn or winter.^[2]
- If you already have a succulent cutting, skip to the next section, on planting the cutting. Even if you did not follow the steps below to remove the cutting, most succulents still have a relatively high chance of propagating.
2
Sterilize a sharp knife. Select a razor blade or sharp knife, capable of making a straight cut through the plant. Reduce the risk of infection by heating the knife blade in an open flame, or by wiping the blade with rubbing alcohol.
- Using pruning shears or hand-plucking methods are not recommended, as they may cause crushed or jagged tears that the leaf cannot properly heal from.^[3] If you do try to pluck the leaf, make sure the entire leaf snaps off the stem, and use a gentle tug, not excessive force.^[4]
Advertisement
3
Decide whether to cut individual leaves or a larger cutting. Most succulents can grow a new plant either from an individual leaf or a stem segment. However, some genera such as Dudleya or Aeonium require a stem segment.^[5] ^[6] Refer to the steps below for more information.
- If you do not know what genus or species your succulent plant is, try either method. The mother plant is unlikely to suffer if you follow the instructions below, making this a low-cost experiment.
- For a few unusual genera, but notably with aloe plants, the plant is best propagated by removing a newly grown "pup".
4
Select a leaf to cut. If your succulent has a "rosette" of tightly circled leaves at the top of a stem, leave that untouched and cut leaves from lower down, but not directly at the base of the plant.^[7] For succulents that mostly grow outward, rather than upward, cut the leaves from the outer edge. Cut leaves where they connect to the stem, making a straight cut.
- Unless you are also taking a stem cutting, skip ahead to the section on planting your cutting.
- See the Tips section if you have a succulent with very large leaves.
5

Select a stem to cut. Most succulents are not difficult to grow, but you can still increase your chances of a healthy plant with the right cutting. Ideally, select a stem that is actively growing, near the top or outer edge of the plant, and 4–6 inches (10–15 centimeters) long.^[8] Cut directly beneath a stem joint, or beneath the point where a leaf or bud joins the stem.^[9] Choose a piece with at least two leaves (or clusters of leaves), if possible.^[10]

Advertisement

1
Strip leaves from the lower part of the stem. If you are using a stem cutting, remove the lowest cluster of leaves. Strip them with the same, sterilized knife, leaving the lowest 2–4 inches (5–10 cm) of the stem bare. Don't remove remaining leaves higher up on the stem cutting.
- If buds are on your cutting, leave them on.^[11]
2
Dip the cut end in a rooting hormone (optional). Commercial rooting hormone powder may hasten the development of the cutting, and often includes an antifungal agent as well to prevent rot. This treatment is recommended for rotting cuttings and for older, "woody" stem cuttings, but is typically not necessary otherwise.^[12]
- Some gardeners report success using ground cinnamon as a cheaper alternative to antifungal treatment, sprinkling it onto the cut end.
3
Let the cutting dry out in a lightly shaded location. Keep the cutting on a paper towel away from direct sunlight, and check on the cut end regularly. The cut should dry out, making the new plant less susceptible to rot. Stem cuttings can be planted after one or two days of drying.^[13] Leaf cuttings undergo a more visible change, growing a "callous" over the cut surface. This can take anywhere from two to seven days.^[14]
- If a leaf shrivels significantly during this time, you may need to plant it early. This has a lower success rate, but the leaf may die if it dries out completely.
4
Prepare a succulent potting mix. While waiting for the cuttings to dry, fill a small pot with a fast-draining succulent or cactus potting mix. If you wish to make your own, mix together three parts potting soil, two parts sand, and one part perlite.^[15]
- Use coarse, salt-free, store-bought sand if possible, since hand-gathered sand may contain microorganisms or salts that could harm plants.
5
Select an appropriately sized pot to plant your cutting. Succulent plants thrive in pots that aren't too much bigger than the plant itself. Pots that allow for about an inch or two of growing room should be fine while the cutting is getting started.
- The pot must have a drainage hole.
6

Plant the cutting. Stems cuttings can be planted as usual, burying the stem until the lowest leaves are just above the soil, but not touching it.^[16] Buried leaves are more likely to rot, so if you have a leaf cutting, try just touching the cut end to the soil surface, propping the leaf up with pebbles.
7
Water occasionally. Succulents don't need a lot of water, in general. Still, you'll need to water cuttings every 2 to 3 days or so while they establish roots. Once the plants have started to build a root system, you can cut down to weekly watering or whenever the soil is dry.^[17]
- Don't be worried if the cuttings look like they're drying out, at first. This means the plant is using its stored energy while it puts down new roots.
- If things work, you should start to see new growth in about 4 weeks.
Advertisement

1
Place the plant in a warm, airy location. Young succulents may not have the water supply to withstand direct sunlight, unlike adult plants. They do best in indirect sunlight, temperatures of around 68ºF (20ºC), and in locations with good air flow.^[18]
- Many succulents actually do better in indirect light, even after they're well established.^[19]
2
Keep the soil slightly moist. Young succulent cuttings need a regular supply of water in order to stay alive and develop roots. However, succulents are adapted to dry climates and will usually rot if kept in soaking conditions.^[20] Try using a spray bottle or small pitcher to add water to the top of the soil as soon as it dries out, about every two or three days.^[21] Mist your leaf cutting directly as well, since it has not yet developed roots.
- If your tap water is heavily chlorinated, or if your cuttings develop rot, try using distilled water.^[22]
3

Reduce watering as the plant develops. A stem cutting may have a sufficient root system after four weeks, at which point you may water as infrequently as once a month.^[23] Leaf cuttings will develop more slowly, but can also be tracked by eye as small leaves and roots emerge from the cut end. Reduce watering frequency gradually once the roots enter the soil, which may take six weeks or longer.
4

Use fertilizer cautiously. Succulents are slow-growing plants, and are not adapted to growing in high-nutrient soil.^[24] Use a balanced fertilizer (for instance, 10-10-10) only during the growing season, and only once the young plant is at least four weeks old, with established roots. Consider using the fertilizer at ½ or ¼ the recommended dose, to prevent the plant becoming overly tall and "leggy" with little foliage, or burning its root system.

Advertisement

Add New Question

Question

How can I tell what type of light a succulent needs?

Chai Saechao is the Founder and Owner of Plant Therapy, an indoor-plant store founded in 2018 based in San Francisco, California. As a self-described plant doctor, he believes in the therapeutic power of plants, hoping to keep sharing his love of plants with anyone willing to listen and learn.

Plant Specialist

Expert Answer

It really depends on the specific species of the succulent, although most succulents do pretty well in indirect or shaded light. You can normally get an idea by looking at the leaves. If the succulent has a waxy, glossy texture, then it probably prefers indirect sunlight. The rougher succulents with a harder feel typically want to be in direct sunlight.
Question

Can you root a snake plant in water?

Maggie Moran is a Professional Gardener in Pennsylvania.

Home & Garden Specialist

Expert Answer

Planting a snake plant in water is one of the best ways to propagate the plant. However, keep in mind that too much water can kill the plant.
Question

Do the leaves of succulents grow back?

Maggie Moran is a Professional Gardener in Pennsylvania.

Home & Garden Specialist

Expert Answer

The succulent will grow new leaves as it matures, while the older ones fall off.
Question

How do I propagate a succulent from a leaf?

Maggie Moran is a Professional Gardener in Pennsylvania.

Home & Garden Specialist

Expert Answer

You lay the leaves flat on dry Cacti mix and keep them in bright but indirect light. Once the cut edges are calloused over, spray the edges lightly once a week. After a week or two, roots will be seen on the eyes of the leaf.
Question

How do I propagate a Kalanchoe plant?

Maggie Moran is a Professional Gardener in Pennsylvania.

Home & Garden Specialist

Expert Answer

Take 2 or 3 inches of stem and shear off the leaves at the bottom. Allow a callus to form at the edges by letting the cutting sit in a warm and dry location. In an already moistened peat and perlite pot, plant the cutting up to the first leaf. Once planted, wrap the pot in plastic to ensure the moisture remains inside.
Question

How do you stimulate the root of a succulent?

Maggie Moran is a Professional Gardener in Pennsylvania.

Home & Garden Specialist

Expert Answer

If you're propagating a leaf cutting, a little succulent or cactus mix can help. To propagate a succulent from leaves, you lay the leaves flat on dry cactus mix and keep them in bright but indirect light. Once the cut edges are calloused over, spray the edges lightly once a week. After a week or two, roots will be seen on the eyes of the leaf.
Question

Should I put succulent leaves in water?

Maggie Moran is a Professional Gardener in Pennsylvania.

Home & Garden Specialist

Expert Answer

You can choose to root your succulents in either soil or water. However, make sure that you have dried your cuttings for several days beforehand.
Question

What climate zones are recommended for succulents?

Maggie Moran is a Professional Gardener in Pennsylvania.

Home & Garden Specialist

Expert Answer

While succulents generally do best in hot areas, most will thrive in zones 3 to 9.
Question

How long will it take to grow roots?

About 4 weeks in warmish weather if you're keeping them moist every day.
Question

Which succulents make it through Missouri winters?

Hens and chicks will survive a mild winter. Hens and chicks are members of the Sempervivum group of succulent plants. They are commonly called houseleeks and grow well indoors and out, in cool or hot temperatures.

See more answers

Ask a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Video

A few large-leaved species of succulents can even be grown from partial leaf cuttings:^[25]
- Streptocarpus species can have the leaves cut in half lengthwise, discarding the central rib, and inserted cut side down into a shallow trench.
- Sansevieria and Eucomis species can have leaves cut widthwise into 2 in. (5 cm) long sections, inserted with the downward side ¾ in. (2 cm) deep.
- Begonia and Sinningia can be cut into leaf segments 1 in. (2.5 cm) square, each with a large vein present. Attach these flat onto the soil with a thin, sterilized pin.

If the plant is spiny or spiked, wear thick gloves or wrap your fingers in tape before handling the plant.

About This Article

Article SummaryX

To propagate your succulent plant cutting, start by stripping the lowest cluster of leaves off the cutting, leaving the lowest 2-4 inches of the stem bare. Then, put your cutting on a paper towel somewhere slightly shaded, and let it dry for 1-2 days. Next, find a pot that's just a bit larger than your cutting, and fill it with a succulent or cactus potting mix. Plant your cutting in the pot so its lowest leaves are just above the soil. Finally, water your cutting every 2-3 days until its root system is established, and once a week after that. To learn from our Horticultural reviewer how to take your succulent cutting, scroll down!

Did this summary help you?

Thanks to all authors for creating a page that has been read 511,846 times.